Epygi QXE1/T1 Gateway
The QXE1/T1 is the complete PSTN/VoIP gateway for growing small businesses that want to establish for example a corporate telephone network. Connected over an E1/T1 voice trunk for up to 23 (T1) or 30 (E1) concurrent calls to a PBX or directly to the local PSTN and via Ethernet to the Internet, the QXE1/T1 seamlessly combines the cost reducing benefits of IP technology with the ubiquity of the PSTN, which opens a multitude of scenarios for free phone calls all over the world. For more information visit http://epygi.com
The QXE1/T1 can be configured to fit up to 4 units side by side in a 1 U rack space (1.75"). The device comes with a redundant power cable, allowing two devices to have their own power, with a simple power cross connect to provide power to another unit in case of a power failure or power supply failure.
QXE1/T1 gateway configuration for sipXcom
Please refer to Epygi QXE1/T1 manual for detailed information on how to configure QX E1/TA Gateway features. The examples below uses the QX E1/T1 simply as a gateway, and does not use the included Router functions. In this use case, the router is connected to a PRI connected to a local central office, and the Ethernet port is connected to the same local area network the sipXecs server is connected to.
There are other use cases for the product, but this document does not attempt to provide installation assistance with those use cases.
Configuring connectivity to sipXcom server
Log into QX E1/T1 Gateway and Run System Configuration Wizard.
Host Name – Give this device a unique Hostname
Domain Name – enter domain name used on sipXcom Server
IP Address – Provide unique IP address on same subnet as sipXcom Server
Subnet Mask – Provide Subnet Mask appropriate for this subnet
It is recommended that the Quadro is not used for the DHCP.
Untick the DHCP Option
Locale – Select Country where Quadro is being installed
Timezone – Select correct timezone.
View Summary Screen
Run Internet Configuration Wizard
Uplink Configuration - Select Ethernet. Set speed to appropriate setting.
WAN IP Configuration - Select IP method – DHCP or Manual. Enter WAN IP if Manual
PPTP Configuration Settings
Wan Interface Configuration
Enter DNS address for the Network
Review Summary Page
Configure E1/T1 Settings
Interface Type - If QXE1/T1 is connected to a PBX, select Network for your interface type. Otherwise, select User
Select Signaling Type – CAS or CSS CSS=PRI
If you select CCS signaling type, you will be taken to a new screen – Signaling Type CCS
Enter PRI configuration information provided by your PRI service provider.
Under Route Incoming Call – Select Route with Inbound Destination Number
Configuring SIP server and registrar
Under Gateways in the sipXcom server, create a new unmanaged gateway using the IP address of the QX E1/T1 Gateway. Apply the configuration and Send the profile to create the configuration file.
Under Dial Plans, select the dial plans this gateway will be used for and apply it as a gateway for these dial plans.
The QX has extensive troubleshooting methods build into the system. These include packet captures, network port statistics, ISDN signaling traces, etc.