Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

Detailed Information

Children Display

Supported Models And Features

...

AudioCodes gateways can be managed automatically by sipXecssipXcom.  Some DHCP configuration changes are required however to make things work properly. The steps required are:

  1. Upload Device Files to sipXecssipXcom
  2. Add Gateway to sipXecs sipXcom and Generate Profile
  3. Configure DHCP

...

To upload device files to sipXecssipXcom:

1. Login to the GUI as superadmin.

...

4. Give the device files a descriptive name as shown below and click on OK.
5. Back in the Device Files list, click on the name of the newly added device file entry and the following page will be displayed:
6. Click on the Browse button and locate the firmware file you'd like to use.  After the file is selected, click on the 'Activate' button and the firmware will be uploaded and set to 'Active'.

Add Gateway to

...

sipXcom and Generate Profile

To add a gateway to sipXecssipXcom:

1. Login to the GUI as superadmin.

...

To configure DHCP, ssh to the sipXecs sipXcom system and login as root.

...

  • Add a 'next-server' option into the subnet that will contain the AudioCodes gateway.
  • Add a 'group' section to the subnet.  This will contain the host entries for the gateways.
  • Add a 'host' section for each gateway.  Note that case in MAC address and file names is important!
  • The 'filename' is a concatenation of the firmware file name followed by the name of the ini file generated by sipXecssipXcom.

After dhcpd.conf file is edited, restart the dhcpd service. To do this enter: service dhcpd restart

...